Once you have downloaded your new driver, you'll need to install it. In Windows, use a built-in utility called Device Manager, which allows you to see all of the devices recognized by your system, and the drivers associated with them.
If you could not find the exact driver for your hardware device or you aren't sure which driver is right one, we have a program that will detect your hardware specifications and identify the correct driver for your needs. Please click here to download.
Winbond W89c940 Driver Download Download Full Version
NICPAK has been tested with Warp 4 FP15, WSeB FP2, and eCS (MCP). It may run on earlier fixpack levels if the necessary Rexx updates are in place. Some older motherboards do not appear to correctly identify some NICs or, in some cases, the PCI bus itself. If you can manually identify your NIC, you can download, unzip, and manually install an available driver that is listed below.
Run NICPAK.CMD to determine if a driver is available. If so, you can then download the driver file package, unzip it to the same work directory where you unzipped nicpak.zip without junking the paths (or with PKUNZIP, using the -d parm), and run NICPAK.CMD again to install/update the NIF and driver files in IBMCOMMACS. You then must run the MPTS configuration to add to and/or update your protocol.ini file. If you allow NICPAK to invoke the MPTS command, it will validate any changes made to IBMCOMPROTOCOL.INI against the values in IBMLANIBMLAN.INI. Even if you chose to make no updates with the NICPAK.CMD, you will still be asked if you would like to make the INI file comparison.
To check your version of Windows for IEEE-1394 compatibility, see"Windows Limitations," Chapter 1. Also, make sure you have drivers foryour drive and version of Windows. You might need to download drivers for yourversion of Windows from the manufacturer, particularly if you use WindowsXP.
Before you connect a USB drive to your system, make sure the port is enabledand supported in your version of Windows. To do this, open the Device Managerand verify that the port is listed and that it is not reporting any problems.Also, make sure you have drivers for your drive and version of Windows. Youmight need to download drivers for your version of Windows from themanufacturer, particularly if you use Windows XP with the newer USB 2.0 portsand devices. Depending upon the drive, you might need to install its driversfirst before you connect the drive to the system; check the drive'sdocumentation to find out.
However, as with any device, you need to make sure you have drivers for yourdrive and version of Windows. You might need to download drivers for yourversion of Windows from the manufacturer, particularly if you use WindowsXP. 2ff7e9595c
Comments